Koro SIR MIX-A-LOT Manuel D'utilisation page 10

INTRODUCTION TO THE CONTROL PANEL
Power Switch --- "ON" position starts blender. "OFF" position stops blender.
Speed knob – Adjusts blender speed. Start from "MIN" and turn knob towards "MAX" to increase speed;
Turn knob from "HIGH" to "LOW" to reduce speed.
Caution: Always start the blender from LOW speed position.
Pulse switch --- "ON" position overrides variable speed setting and runs blender at full speed;
Release the switch to select "OFF" position and blender reverts back to variable speed setting.
OPERATION
Before starting, check and make sure the followings:
The JAR is fit already securely and completely to Blender base.
The LID is fit already on the JAR and in locked position
The SPEED KNOB is in low speed position
Plug on the Blender, get ready to use.
This machine is built-in a safety device, please place the Jar stably on the Blender base,
then can trigger the safety switch to enable the machine to work.
Fill the food material into the Jar, do not exceed the MAX marking on the Jar.
Dial the Speed Knob to be on Min position, then turn on the machine to start work, then dial the
Speed Knob to appropriate speed for operation.
Pulse Switch: Turn it to be ON position, machine work at maximum speed, keep it work for a few
seconds and repeat it for every 1-3 seconds, then according to the food processing condition,
turn to regular operation by Speed Knob.
When finish, turn off the machine, wait until the machine stop completely, then take the Jar off the
machine to pour the finished foods out.
Blending Tips:
When pouring the food materials into the Jar, please be aware of the order. Please put liquid type
of food and soft food material 1stly, then put ice, then add solid food materials.
It is better to use slow speed to start then turn into high speed for food material which required more
process or sticky food. Processing hot food or when there are too much food material inside the Jar,
please make sure to start with slow speed then transit to high speed.
Pour the ice into the container, add water until about 3/4 full and let the ice float above the ice
~1.25cm. Set at high speed for 2~3 seconds, then filter out the water.
During blending process, if the food materials are been pushed toward the Jar wall, it means the
RPM is too high, speed should be reduced. On the other hand, if the food materials are moving
above the blade, it means the speed is too slow, needs to increase speed.