Publicité
Les langues disponibles
Les langues disponibles
10x15 spacers' location
Fitting kit
- 4 BHc 6×35 screws
- 1 metallic support
- 4 BHc 5×10 screws
Assembly
- Remove the original number plate support and disconnect the plate lighting.
- Plate lighting must be fitted as follow :
- Fit together the metallic holder and the plastic part thanks to the provided Ø5 screws, washers and nuts.
- Place the spacers as shown on photos.
- Connect the plate lighting and fit the plate holder on the motorbike with the 4 BHc 6x35 screws and the Ø6 plastic
washers.
- Fit the number plate on its support.
It is advised to check the slope of the number plate before assembly, and if necessary,
fold the support metal plate so as to preserve a slope in the standards (do not fold the
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of
our painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicules made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* A few tyres, as Dunlop D207 or Michelin Pilot Power, not being for the given dimensions, are not compatible with undertray and rear hugger made for original tyres in standard dimensions.
* Harden the rear shock absorber while drivings with load or on dented roads.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
- 4 Ø6 plastic washers
- 2 Ø6 L : 17mm spacers
- 4 Ø5 plastic washers
metal plate while fitted on the ABS piece).
« ATTENTION »
FITTING INSTRUCTIONS
« PLATE HOLDER »
GSXR 600 / 750 2008/2010
6x17 spacers' location
- 2 Ø6 L : 5mm spacers
- 2 Ø6 L : 10mm sapcers
- 4 Ø5 nylock nuts
Publicité
