Publicité
Les langues disponibles
Les langues disponibles
Parts numbered 1 and 2 are to be retained.
Remove pieces not required as above.
Fitting kit
- 2 bevelled spacers
- 1 Ø5 plastic washer
Assembly
- Remove seat, passenger grab rails, lock bracket, light unit and indicators.
- Remove the original undertray and cut it as shown above. Replace it on motorbike.
- Re-fit rear light on its bracket and refit the unit on the bike. Slide the undertray on from the rear of the bike.
- Re-fit the rear bodywork. Once in place, replace the lock bracket.
- Fit the passengers grab rails and ensure that lights & indicators functioning correctly.
- Bore the original undertray through the provided one and fix both using screw, plastic washer and nylock nut provided.
- Replace the seats and fit licence plate to the supplied undertray.
- It is advised to check the slope of the number plate, and if necessary, fix the plate with the supplied bevelled spacers.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicules made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Any deterioration of the parts due to the presence of any excessive load in the undertray will not be guaranteed.
* A few tyres, as Dunlop D207 or Michelin Pilot Power, not being for the given dimensions, are not compatible with undertray and rear hugger made for original tyres in standard dimensions.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
2
- 1 BHc 5×25 screw (little head)
- 1 Ø5 nylock nut
* The "Ermax" hugger and undertray are compatible with each other.
Original tyre Michelin Pilot Road in 160/60 ZR 17.
1
For CBF 600 2008 models and following.
The parts with double hatching are to be removed. Fit the original
undertray on the framework with the provided plastic collars.
Original undertray after cutting for
CBF 600 2008 and following
- 2 plastic collars
WARNING
FITTING INSTRUCTIONS
« UNDERTRAY »
CBF 500 & 600 2004 → ∞
& CBF 1000 S 2006 → ∞
Publicité
