Setup; Setup Location Requirements; Avoiding Radio Interference - Caso Germany MCDG 25 Master Mode D'emploi Original

11.5 Setup

11.5.1

Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the
setup location must fulfil the following prerequisites:
•
The device must be set up on a firm, flat, horizontal and heat-resistant
surface with sufficient load-bearing capacity for the oven and the
maximum weight of the expected food that is to be prepared in the
oven.
•
Choose the setup location in such a way that children cannot reach any
hot surfaces on the device.
•
The device is not intended to be installed in a wall or a built-in
cupboard.
•
Do not set up the device in a hot, wet or extremely damp environment
or near flammable material.
•
The device requires an adequate flow of air in order to operate
correctly. Leave a clearance of 20 cm above the oven, 10 cm around
the back and 5 cm on both sides.
•
Do not cover up any openings on the device and do not block these off.
•
Do not remove the device's adjustable feet.
•
The electrical socket must be easily accessible so that the power lead
can be disconnected easily, in the case of an emergency.
•
The installation and assembly of this device in non-stationary setup
locations (e.g. on ships) must be carried out by specialist companies /
electricians, provided they guarantee the prerequisites for the safe use
of this device.
11.5.2

Avoiding radio interference

The device can cause the occurrence of interference in radios, televisions
or similar devices.
Such faults can be rectified or reduced as a result of employing the
following measures:
•
Clean the door and the sealing surfaces of the device.
•
Set the radio, the television, etc as far as possible away from the
device.
•
Connect the device to a different electrical outlet, so that various power
circuits are used for the device and the receiver with the interference.
•
Use a properly installed antenna for the receiver, to ensure good
reception.
caso MCDG 25 Master 54