Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 4 BHc 6×35 screws
- 4 M6 nylock nuts
- 4 Ø6 plastic washers
Assembly
- Remove the rear passenger saddle, disconnect indicators and remove the original number plate
support.
- Connect the indicators and plate lighting. Place the provided plate holder and fit it thanks to the
furnished screws.
- Fit the number plate on its support.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the
technical data of our painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicules made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* A few tyres, faithful to ETRTO standards, may be in fact bigger and higher than dimensions engraved on the tyre (until + 10 mm). They may be not compatible with undertrays and rear huggers which we
made with original tyres and whose dimensions correspond to these ones engraved on tyre.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
FITTING INSTRUCTIONS
« ATTENTION »
« PLATE HOLDER »
R6 2006/2007
Publicité
