Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 4 fitting brackets
- 3 BHc 5x20 screws
- 4 BHc 5x15 screws
- 4 Ø5 plastic washers
- 1 central part
1
Assembly
- Place the fitting brackets as indicated on photos. Brackets n°1 and n°4 must be fitted on the
screws of the intermediate casing : tighten them later at the torque wrench of 24 n/m. Fit the
bracket n°3 on the screw of the lower casing (the closest of the oil filter) : tighten it later at the
torque wrench of 10 n/m.
- Place the silent blocks into foreseen holes.
- Position the belly pan to well place fitting brackets. Assemble the 2 sides of the belly pan
thanks to the central part and the BHc 5x15 screws. Place nylock nuts and washers between the
screw and the belly pan not to damage the painting.
- Place the remaining screws to fit the belly pan. Check that the belly pan is well clear of the
exhaust pipes or all other parts that may damage it. Tighten definitely casing screws at the torque
wrench indicated above.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Belly pans will be neither retaken nor exchanged in case of rubbing during a "sports" driving, or during the clearing of pavements, uneven road surfaces ... The fitting of Ermax accessories is planned for a normal road use.
* Move hoses so that they do not fall inside the belly pans. Any deterioration due to flows of corrosive products is not guaranteed.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
- 3 Ø5 fasteners
- 1 BHc 6x20 screw
- 4 Ø5 nylock nuts
- 4 silent blocks with metallic spacer
- 2 pieces of alu nettings 17 x 3 cm
2
« CAUTION »
FITTING INSTRUCTIONS
« BELLY PAN »
CB 1000R 2008 → ∞
3
4
Publicité
