Ermax 7301096 Notice De Montage page 2

Fitting kit
- 2 BHc 6x15 screws big head
- 2 Ø6 rubber washers
- 2 BHc 5x25 screws little head
- 2 Ø5 plastic washers
Assembly
- Fit the rear hugger with the Ø6 screws on the chain-guard side.
- For 600 Hornet 2011 and following, use the Ø5 screws at right to maintain the brake hose.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of
our painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* A few tyres, faithful to ETRTO standards, may be in fact bigger and higher than dimensions engraved on the tyre (until + 10 mm). They may be not compatible with undertrays and rear huggers which we made with
original tyres and whose dimensions correspond to these ones engraved on tyre.
* Harden the rear shock absorber while drivings with load or on dented roads.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
FITTING INSTRUCTIONS
CB 600 HORNET 2003 → ∞
« CAUTION »
« REAR HUGGER »
CBF 600 2008 → ∞