Publicité
Les langues disponibles
Les langues disponibles
Fixing kit
- 1 plastic ring
- 1 self-adhesive pad
- 2 plastic washers Ø6
Assembly
- Remove the chain guard and the brake hose fixing bracket.
- Fit the rear hugger with the provided screws and washers but do not tighten completely : the screw Ø5
should be used on the right hand side of the bike. Ensure that the rear hugger is well centered and then
tighten screws fully.
- Stick the self-adhesive pad on the rear hugger and then attach the brake hose using the plastic ring as
shown in the picture.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of our
painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* The mentioned label of motorbikes's manufacturers are indicated exclusively as a reference to Ermax accessories.
* Care to excessive clampings which may damage or break our plastic accessories and aluminium screws.
* A few tyres, faithful to ETRTO standards, may be in fact bigger and higher than dimensions engraved on the tyre (until + 10 mm). They may be not compatible with undertrays and rear huggers which we made with original
tyres and whose dimensions correspond to these ones engraved on tyre.
* Harden the rear shock absorber while drivings with load or on dented roads.
ADAPTABLE ON NC 700 X/S 2012 → ∞
- 1 plastic washer Ø5
- 2 screws BHc 6×15 (big head)
- 1 screws BHc 5×15 (big head)
Self-adhesive pad and ring
« CAUTION »
FITTING INSTRUCTIONS
ERMAX REAR HUGGER
Publicité
