Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 4 BHc 6×30 screws
- 4 Ø6 plastic washers
- 4 Ø6 length 10 mm spacers
- 2 beleved spacers
Assembly
- Remove both saddles, the rear fairing and disconnect the plate lighting.
- Remove the original number plate support.
- Place the plate holder and connect the plate lighting.
- Replace the rear fairing and both saddles.
- Fix the plate holder thanks to the furnished screws and washers by inserting the spacers between
the plate holder and the original undertray.
- If necessary, fix the plate with the supplied beleved spacers.
The part may be damaged because of an excessive tightening, which is not guaranteed.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of
our painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicules made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* A few tyres, as Dunlop D207 or Michelin Pilot Power, not being for the given dimensions, are not compatible with undertray and rear hugger made for original tyres in standard dimensions.
* Harden the rear shock absorber while drivings with load or on dented roads.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
« ATTENTION »
"ATTENTION"
FITTING INSTRUCTION
« PLATE HOLDER »
GSXR 600 / 750 2006/2007
GSXR 1000 2005/2008
Publicité
