Getting Started - DNT MusicFly Select Mode D'emploi

All manuals and user guides at all-guides.com

Getting started

Place the MusicFly Select into the 12V cigarette lighter socket
power. Adjust the device, that it can be operated comfortably.
The display appears immediately. The equipment is ready for
use. The MusicFly Select checks whether a device is attached
to the USB port or a SD card is in the card slot and starts to
playback the music.
Switch on from standby mode
Press and hold the POWER button for 2 seconds
to turn the unit on. The previous display settings
appear. The MusicFly Select checks whether a
device is attached to the USB port or a SD card is in
the card slot and starts to playback the music.
Switch off
The unit switches off automatically after 60 minutes when no
music is played . Alternatively the unit can be switched off with
the POWER button
Standby Mode
If no audio device is connected to the USB port, SD card slot
or audio in or the device is in PAUSE mode the device turns off
after 1 Minute. A noise is heard in the radio. If the audio device
is connected to the MusicFly Select in the next 60 Minutes, the
device turns itself on automatically, otherwise turn the device
on with the POWER button.
If the menu for the settings is active, then a LED
below the MENU/REPEAT button appears.
Setup fequency manually
Press the MENU/REPEAT-button.
Adjust the frequency with the
Press the MENU/REPEAT-button once again.
Setup fequency automatically
Press the SEARCH-button.
The display shows
ning a new frequency.
Getting started
/ -buttons.
Ato
shortly and starts scan-
- 21 -