Daspi RX MULTI Manuel D'utilisation page 4

5. Programming one button or remote:
1. First, select the DIPs combination of the chosen remote's
brand that will be programmed following table 1.
2. Press the learn button (S1 or S2), the corresponding LED turns
on.
3. Press the button of the remote you want to program the LED
L1 or L2 flashes for 5 seconds, this shows remote button
entered the RX Multi successfully.
Repeat steps 2 and 3 for another button or remote.
6. Erase all data in memory card:
By pressing for few seconds the button S1 or S2, the LED will be fixed. Keep
pressing this button until the LED turns off. All data in the memory card will be
erased permanently.
NOTICE: Be careful at erasing all data in the memory card. The data will be
erased permanently and CANNOT be recovered.
DS001 RX MULTI
V02
4