N-Com MCS II Sécurité Et Instructions D'utilisation page 14

Fig. 19
Before you place the speaker in its housing, apply the Velcro pad to the

polystyrene cheek pad (right side).
Position the loudspeaker in its housing obtained in the polystyrene cheek pad

(right side).

Replace the polystyrene cheek pad (right side), positioning the cable in the groove
you see in the cheek pad.
14
Fig. 20
 Position the loudspeaker in the
special housing obtained in the
polystyrene cheek pad (Fig. 19).
Replace the polystyrene cheek

pad (left side), positioning the
cable in the groove that you see
in the cheek pad (Fig. 19).
Note: Make sure the cheek pad is
properly positioned in its housing,
pushing in
underneath the ribbing on the
shell (Fig. 20).
the lined corner