Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. START-UP:
1.
Turn on water.
2.
Check for leaks.
3.
Turn on power.
4.
Open Rite-Temp valve. Turn Rite-Temp valve stem
clockwise to open, counterclockwise to close. When mixer is
opened, initial flow will be through hand shower.
5.
See Fig. #20 . The keypad controls tower assembly outlets
and flow patterns. Turn on valve. Make desired adjustments.
Hand Shower
Body Sprays
Body Spray
Pulse
6.
See Fig. #21 . Check body sprays for smooth operation.
7.
Push body button to enable pulse and sweep functions.
8.
The left button below this provides stop/start pulse action and
the lowermost buttons adjust rate up and down.
9.
The right button below the central button provides start/stop
sweep action and the lowermost buttons adjust speed up and
down. If body sprays are sweeping when stop is pressed,
sweep action will continue until body sprays re-center.
10.
To adjust spray pattern individually on body sprays, adjust the
body spray outer ring clockwise for concentrated (hard)
spray, and counterclockwise for full (soft) spray.
11.
The height angle of the body spray may be adjusted by
swiveling the entire exposed body spray assembly upward or
downward.
12.
See the Owner's Manual, if necessary, for additional
operating instructions.
Kohler Co.
Sheetflow
Dual Function
Buttons
Body Spray
Sweep
Fig. #20
13.
See Fig. #22 . Check sheetflow for smooth, even flow. Press
the upper right button on the keypad for sheetflow-only flow.
Continuity of the sheetflow action will depend on water
pressure and number of outlets operating.
9
Body Spray
Button
Body
Sprays
Fig. #21
Sheetflow
Sheetflow
Button
Fig. #22
1017708-2-
A
Publicité
Table des Matières
