Signal Connections - Chauvet Professional Ovation B-565FC Manuel De Référence

Masquer les pouces Voir aussi pour Ovation B-565FC:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Replacing the Fuse
1.
Disconnect this product from power.
2.
Using a Phillips #2 head screwdriver, unscrew the fuse holder cap from the housing.
3.
Remove blown fuse and replace with a good fuse of the same type and rating.
4.
Screw the fuse holder cap back in place and reconnect power.

Signal Connections

You can link the Ovation B-565FC to a controller or controller software using a DMX connection or an Ethernet
connection. If using other Art-Net™ or sACN-compatible products with the Ovation B-565FC, you can control each
individually on a single network. See the User Manual for information about how to connect and configure the product for
these signals.
Control Personalities
The Ovation B-565FC uses DMX, Art-Net™, and sACN for its 17 control personalities, ranging from 3CH to 31CH in
1-cell modes and 2-cell modes:
M
ODE
DMX-VCW-CCT
RGB
RGBA
RGBAL
RGB EXT
RGBA EXT
RGBAL EXT
RGBAL Fine
RGBAL FULL
DMX Connection
The Ovation B-565FC will work with a DMX controller using a 3- or 5-pin DMX data connection. A DMX Primer is
available from www.chauvetprofessional.com.
Art-Net™ Connection
Art-Net™ is an Ethernet protocol that uses TCP/IP which transfers a large amount of DMX512 data using an Neutrik®
etherCON® RJ45 connection over a large network. An Art-Net™ protocol document is available from
www.chauvetprofessional.com. Chauvet Professional recommends using unicast Art-Net™ for best results.
Art-Net™ designed by and copyright Artistic Licence Holdings Ltd.
sACN Connection
Also known as ANSI E1.31, Streaming-ACN is an Ethernet protocol that uses the layering and formatting of Architecture
for Control Networks to transport DMX512 data over IP or any other ACN compatible network. ACN is maintained by the
Professional Lighting and Sound Association (PLASA).
Master/Slave Connection
The Ovation B-565FC uses the DMX data connection for its Master/Slave mode. See the User Manual for information
about connect and configure the product for master/slave operation.
Ovation B-565FC QRG Rev. 1
QUICK REFERENCE GUIDE
1-C
2-C
ELL
ELL
3
N/A
3
6
4
8
5
10
8
15
9
17
10
19
10
20
17
31
EN
2

Publicité

Table des Matières
loading

Table des Matières