Cleaning Modes; Different Methods Of Cleaning; Series Features - Shesto UT8021/EUK Mode D'emploi

Cleaning Modes

Degas Mode: Degas mode will start intermittent operation of the ultrasonic power. This ensures
rapid removal of air from liquids. This can be started via the degas button. This button will also
stop the cleaning prior to timed ending if needed.
Delicate Mode: The ultrasonic cleaner delivers half power to provide a less aggressive clean for
delicate items. To start the delicate mode press the delicate button. This button will also stop the
cleaning prior to the timed ending if needed.
Full Mode: The ultrasonic cleaner delivers its maximum ultrasonic power to provide an
aggressive clean for heavily soiled items. The full button will start Full mode on your ultrasonic
tank. This button will also stop the cleaning prior to the timed ending if needed.

Different Methods of Cleaning

General Cleaning: For lightly soiled objects we suggest only using warm water. This should be
paired with a temperature around 40°C .
Enhanced Cleaning: If the objects in question need a deeper clean then we advise the use of
an ultrasonic cleaning solution mixed weakly and heated to the mid range of the fluids operating
temperature. Again a warm temperature between 40-60°C will help you achieved your desired
results.
Extensive Cleaning: For the removal of tarnish, fuel and hard carbon deposits, and rust from
non-plated metals, etc, we recommend a pre-soaking in the ultrasonic bath of detergent/solvent
mixed to its strongest concentration ratio to soften unwanted deposits whilst heated to the high
end of the fluids operating temperature range. These steps coupled with the Full mode will
ensure the best cleaning possible.
For more information on the range of solutions visit page 8.

Series Features

Heat Selector
Degas Mode
Delicate Mode
Full Mode
Ultrasonic Cleaner User Manual
Time Selector
6
Stainless Steel Tank
Warning Logos
Digital Displays