Hard Wiring Installation; Hard Wiring Connection - Napoleon Woodland NEFI18H Manuel D'installation

installation
EN
2.2

hard wiring installation

WARNING
!
• Turn off the appliance completely and let cool before servicing. Only a qualifi ed service person should service
and repair this electric appliance.

HARD WIRING CONNECTION

If it is necessary to hard wire the appliance, a qualifi ed electrician must remove the cord connection, and wire
directly to the household wiring. The wire and power supply breaker must be rated for 120V and a minimum of 15
Amps.
This log set must be electrically connected and grounded in accordance with local codes, if hard wired. In the
absence of local codes, use the current CSA C22.1 CANADIAN ELECTRICAL CODE in Canada or the current
ANSI/NFPA 70 NATIONAL ELECTRICAL CODE in the United States.
NOTE: There are 3 wires from the appliance junction; white (neutral), black (power L1) and green
(ground) that connect to 120V power supply (breaker panel), see below.
A.
Remove the securing screws (2) from the electrical cover plate, located on the rear of the log set.
B.
Add an electrical box connector and feed the supply wires through the 7/8" (22mm) hole.
C.
Separate the black, white and green wires that have the wire nuts on them.
D.
Remove the wire nuts and secure the black wire (power L1) to the black (power L1) lead of the power
supply. Connect the white wire from the appliance to the white (neutral) wire from the power supply.
Connect the green wire to the ground wire.
E.
Resecure the cover plate.
BLACK
WHITE
GREEN
10
W415-1654 / D / 02.18.20
(L1)
(N)
(G)
WIRE NUT
WHITE
BLACK
WHITE
GREEN
BLACK
GREEN
NOTE: To aid with moving the
appliance, leave enough wire so
that the log set can be removed
from the enclosure without
BLACK
disconnecting the power supply.
WHITE
If servicing, shut off power
GREEN
supply.
White, Green and
Black wires:
Connect to 120V
power supply.