Instruction Manuals; En Introduction - Texecom Premier Elite Micro Contact-W Mode D'emploi

7.0 Instruction Manuals

7.1 EN Introduction

When using Premier Elite Firmware Version 2.10 and above the
dedicated Ricochet learn menu can be accessed via the omit key when in the
Engineers menu. For all other firmware versions please refer to the Premier
Elite 8XP-W/32XP-W Installation Manual.
When using the Premier Elite Micro Contact-W on an Entry/Exit route, or
a 24HR door, or where chime is required, the device attributes should be
left at default "Always Awake".
See the Premier Elite 8XP-W/32XP-W Installation Manual for details of how to
change the device attributes and learning.
1. Learning the device to the system
Select an empty zone slot for the device and put the system in learn
mode. To power up press and hold the button on the front of the device for
3 seconds (see
The LED will flash pink while it communicates to the receiver. The LED will
turn green if the device has successfully learnt onto the system
and the LED will automatically indicate magnet positioning function for the
next 10 minutes
failed.
Check the system is in learn mode.
Move closer to the panel or expander.
Ensure you are learning the device to an 'empty' zone.
If the device needs relearning to a different zone or system, the battery must
be removed and then re-inserted to initiate the learn process.
2. Magnet positioning
Mount the device and position the magnet so the notches are aligned
until the LED pulses green indicating a secure state
If the device LED pulses red
the device until the LED turns green.
INS741-2 15/25
Fig.1a).
(see step 2). If the LED turns red
(see
(see
Fig.2b) then move the magnet closer to
(see Fig.1b)
Fig.1c) the learn has
(see Fig.2a).