Important; Entering Offline Mode When Operating - Scaime eNodTouch-MS Guide Rapide

•
A terminating resistor can be inserted using the DIP Switch (4-bit) on the rear of the RS-422/485 type. Factory default
settings are all set to "OFF" (no terminating resistor).
Important: GND (SG) must not be connected to ground Shield.

Entering Offline mode when Operating


At Power ON
Touch the upper right corner or upper left corner (within 40 pixels of the edges) of the panel for at least 3 seconds soon after the
startup screen is displayed.
RS422/RS485 terminal Block
Label Meaning
CSB Send Possible B (-)
CSA Send Possible A (+)
ERB Data Terminal Ready B (-)
ERA Data Terminal Ready A (+)
SG Signal Ground
RDB Receive Data B (-)
RDA Receive Data A (+)
SDB Send Data B (-)
SDA Send Data A (+)
1
2
3
4
5
6
7
8
9
Quick Start Guide SCAIME:
11
NUSG-eNodTouch-MS-FE_196776_D.docx

Important:

If the distance
between eNodTouch and
eNod4 is short (<1m),
don't use terminating
resistor on the
eNodTouch side as well
as the eNod4 side.