Introduction; Application Range Of Blitz Gear Plates; 2.2 Warranty And Liability; Safety/Accident Prevention - Blitz GA Pkw Manuel D'instructions

GB
10
Operating Instructions

Introduction

2 Introduction
2.1 Application Range of
BLITZ Gear Plates
BLITZ-gear plates must only to be used for
mounting and demounting of heavy parts
of vehicles (e.g. gear boxes, engines, wheel
shafts etc.) and only in combination with pit
lifts built by BLITZ.
Use of gear plate for other purposes than the
described one is not allowed.
2.2 Warranty and Liability
Generally our "General Conditions of Sale
and Delivery" are valid,which are submitted
at time of contracting. We do not accept any
responsibility if based on one or more of the
following reasons:
• use of the gear plate for other purposes
than the intented one
• disreguard of operating instructions
• repairs beeing carried out inexpertly
• spare parts not originating from BLITZ
• unauthorised technical alternations of the
gear plate
3

Safety/Accident prevention

• The gear plate must only be operated by
persons who have read and understood
this manual.
• In addition to the instructions for use rules
pertaining to other regulations i. e. acci-
dent prevention and environmental rules
have to be observed.
• The instructions for use are constantly
to be kept at the place of operation, thus
being at hand at any time.
• Entering of the load and mounting of the
load carrying device is forbidden.
• Persons are not allowed to stay within the
movement area of the load during the ope-
ration.
• While in motion observe the load.
• Prior to operation check unit upon proper
stage of operation, safe harbouring of the
gear plate on the lift and safe installation
of the lift.
• Lifting and lowering movements must be
carried out evenly.
• When using sharp-edged loads, protect
the nylon belts on all supporting points by
means of the delivered protection hose.
• The centre of mass of the load must be po-
sitioned centricallly above the cylinder of
the lift. Only if this is the case the capacity
can be granted.
• The nylon belts on the gear plate are me-
ant to secure the load but not for lifting of
the load (e.g. with a crane)
3134980 03/13