Switching On The Rc System; Start - Carson Speed Shark Brushed Mode D'emploi

Table des Matières

Publicité

SWITCHING ON THE RC SYSTEM

CAUTION!
Always switch on the
transmitter first, then
the model!

START

CAUTION!
Before using the boat, always check the battery packs and the transmitter batte-
ries !!!
If the boat starts to lose power, return to starting point immediately and replace
or recharge the battery pack.
Brushed Version 500108026
1. Switch the transmitter on first.
2. Now connect the drive battery pack to the drive controller in the boat. (Fig.1)
3. Switch on the boat at the switch (Fig.2). (Acoustic signal is emitted)
4. Check the steering function on the boat stand. (Fig.3)
5. Put the boat into the water and check the drive function.
6. Do this by operating the boat at slow speed, and do not go far from the waterside.
7. If the boat will not move in a straight line, adjust the steering trim "ST Trim" on the
remote control.
8. If all functions are working properly, you can set off.
Binding:
Attention!!! The boat is fully functional when it leaves the factory.
Only use the binding procedure if a malfunction occurs or the drive controller unit
has been replaced.
Instructions
1. Switch on the transmitter
2. Plug the binding cable into the "BIND" socket
3. Switch on drive controller unit (red LED now on permanently)
4. If the red LED continues to only flash, the binding procedure has failed. (Please
repeat)
Fail-safe:
If the radio connection fails during use, the fail-safe function comes into force.
This has already been activated in the factory.
The boat is stopped using a pre-programmed value in the transmitter (neutral position).
GB // 22
ON
1
3
Typical drive controller data:
Model:
Frequency:
Input voltage:
Battery pack:
Output voltage:
Output /
continuous current:
Motor:
2
2-In-1 drive controller
receiver unit
2.4 GHz
6-8.4V
LiIon battery pack,
2 cells
6V-2A
20A
540-550

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Speed shark brushless500108026500108027

Table des Matières