Operating Instructions - Kobalt 1500 PSI Mode D'emploi

OPERATING INSTRUCTIONS

• Turn on water supply at the faucet.
• Make sure the "ON/OFF" switch is in the "OFF" position.
The power switch has international symbols for 'on' and 'off':
On (|) Off (O).
• Unwind the power cord completely and plug
into a grounded 120 volt outlet.
• Release the safety lock button on the spray gun by pressing
the safety lock button from right to left. While pointing the
spray gun in a safe direction, squeeze the trigger on the spray
gun until there is a steady stream of water, letting the water
and air out of the hose.
• Turn the power switch to the 'ON' (|) position. The unit will turn
on for 1 - 2 seconds and shut off. This is a normal function of
the auto start feature. Squeeze the spray gun trigger to begin
pressure washing.
• Squeezing rapidly will cause the auto start feature to miss
an on/off cycle that may prevent it from turning on while
squeezing trigger after rapid squeezing. Use slow deliberate
trigger pulls to avoid such symptoms.
OFF/0
12
OFF/0
ON/I
F
kobalttools.com
ON/I
Unlock