Niko 16-72 Serie Mode D'emploi page 71

16-72X
Installation
Ensure a flush mounting depth of at least 70mm. The receiver is inserted through a 12mm hole
and secured at the rear with the enclosed nut and washer.
The 4-pole mini jack plug can either be plugged directly into the IR-connection block (16-724)
or the 4 signals can be accessed through the connector print (16-729) by means of the 4 screw
contacts (see 'WIRING AND INSTALLATION' p.86). If the cable of the 16-720 receiver is too long
for the installation, it can be shortened. To do this, the individual wires must be stripped. Please
make sure that the connections are made as indicated in the figure below.
EN 71