Important; Safety Advice; Safety Precautions - Rothenberger P63-S6 Manuel D'instructions

GB
INSTRUCTION MANUAL

IMPORTANT

This manual contains information required for safe
use of this equipment.
• Ensure that the user receives a copy of this
manual.
• Keep this manual in a location where the operator
can easily consult it whenever necessary.
• Before using the socket welding device, read this
manual carefully and follow the instructions and
advice it contains.
• Take care to comply with the Safety Measures
described in this manual, to avoid accidents such
as fires, electric shock and other injuries. It is
essential that the personnel that use this
equipment read and understand this manual.
• Ensure that the persons that use this equipment
have the necessary attitudes and aptitudes.
• Do not use the socket welding device in any way
except that described in this instruction manual.

SAFETY PRECAUTIONS

The equipment that you are about to use has been
designed according to the latest techniques and
complies with applicable safety regulations.
Nevertheless, given its nature, its use is potentially
dangerous. To avoid accidents, observe the safety
instructions given in this manual.
These safety instructions are indicated in this manual
by the following icons.
DANGER
Indicates situations that can lead to death or severe
injury for the user.
PRECAUTION
Indicates risk situations that can lead to injuries or
damage to property.
NOTE
Indicates advice that can help to produce the best
results, and other information.
• Please pay attention to these warnings, since they
are important for safe use of the equipment.
• If this instruction manual is lost or damaged,
request a replacement immediately from our
representative.
• Components and specifications are subject to
change without prior notice, in order to improve
the quality or operation of the equipment or to
comply with safety regulations. In this case, the
photographs and illustrations, etc., in this manual
may not correspond to the product supplied.

SAFETY ADVICE

DANGER
1) Ensure that the voltage supply is correct. The
correct voltage is indicated on the name plate of
the main unit or in the instruction manual. If the
wrong voltage is used, this may cause
overheating, smoke or fire.
2) The unit should only be connected to the mains
supply and used for welding once the unit is
attached to the workbench using the G-Clamp.
The legs of the unit should only be used to
handle the unit when cold until it is held firmly in
place with the G-clamp and connected to the
mains supply.
3) Never touch the mains plug with wet hands.
4) Ensure that the unit is installed in a suitable
location.
Do not use this equipment in the rain, in damp or
wet locations, or in locations where water could
easily enter the unit. Never use it in the vicinity of
inflammable liquids or gases, such as petrol or
turpentine. This could cause fires or explosions.
5) Only use the specified accessories and
attachments.
Never use accessories or attachments other than
those specified in the instruction manual or in our
catalogue, otherwise, accidents or injuries could
be produced.