Sharp PS-940 Mode D'emploi page 4

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
4
• Do not attempt to open the product or replace the battery. It is built-in
and not changeable. Use of other batteries may present a risk of re or
explosion and the warranty will be terminated.
• Dispose of batteries according to local regulations. Please recycle when
possible. Do not dispose as household waste or in a re as they may
explode.
• Batteries may explode if damaged.
• Charging the battery using supplied charger or under the charging
condition speci ed in user manual. Charging the battery under any
other conditions may cause the battery to overhead, emit hydrogen gas,
leak, ignite or burst.
CAUTION!
1. Important safety considerations
• Do not expose batteries to high temperatures and do not place them on
locations where the temperature might increase quickly, e.g. near the
re or on the direct sunshine.
• Do not expose batteries to excessive radiant heat, do not throw them
into the re, do not disassemble them and do not try to recharge un-
rechargeable batteries. They could leak or explode.
2. To prevent deterioration or damage to the battery
• Do not drop or subject to strong physical shock.
3. To ensure long battery life
• Do not discharge completely.
How to remove the battery for disposal
RISK OF INJURY. WEAR GLOVES WHEN WORKING!
The battery should be removed by an authorized Sharp service centre.
Not doing so will invalidate any guarantees and warranties on your
device.
Step 1: Remove the 4 screws on the side (2 on left side, 2 on right side) of
the top cover panel.
Step 2: Gently open the top cover panel. You will see the blue battery pack
held in place with a xing bracket.
Step 3: Remove the 2 screws on the battery xing bracket. Slowly lift
the bracket away from the battery (there are adhesive pads between the
battery and bracket that will also need to be separated).
Step 4: Carefully pull the battery wires away from the power board to break
their connections.
Step 5: With wire cutters, cut the wires from the battery that connect it to
the heat sink (cut as near to the heat sink as possible).
Disposal of this equipment and Batteries
• Do not dispose of this product or its batteries as unsorted
municipal waste. Return it to a designated collection point
for the recycling of WEEE in accordance with local law. By
doing so, you will help to conserve resources and protect
the environment.
• Most of the EU countries regulate the disposal of batteries
by law. Contact your retailer or local authorities for more information.
• The shown above appears on electrical and electronivcal equipment
and batteries (or the packaging) to remind users of this. If "Hg" or 'Pb'
appears below the symbol, this mean that the battery cantains traces of
mercury (Hg) or lead (Pb), respectively.
• Users are requested to use existing return facilities for used equipment
and batteries.
CE Statement:
• Hereby, Universal Media Corporation sp. z o.o. declares that this audio
device is in compliance with the essential requirements and other
relevant provisions of RED Directive 2014/53/EU. The full text of the EU
declaration of conformity is available by following the link http://www.
sharpconsumer.eu/documents-of-con rmity
Trademarks:
The Bluetooth word mark and logos are registered trademarks owned by
Bluetooth SIG,. Inc.

Publicité

Table des Matières
loading

Table des Matières