GNC Power Moon Manuel D'installation, D'utilisation Et De Maintenance page 12

When finished, the system will resume the activity interrupted by the DEMO. Similarly, by pressing OK again for three seconds, you can stop the
DEMO function and return to the previous operation.
POWER CONTROL - MANAGEMENT DISPLAY
1 - The display shows the current time.
Press the menu button to switch to the next display.
2 - The display shows the intensity level relative to the bar mounted on channel 1. Use the buttons ˄ and ˅ to set
the desired intensity level. Once the setting is complete, press the menu button to switch to the next display.
3 - The display shows the intensity level relative to the bar mounted on channel 2. Use the buttons ˄ and ˅ to set
the desired intensity level. Once the setting is complete, press the menu button to switch to the next display.
4 - The display shows the intensity level relative to the bar mounted on channel 3. Use the buttons ˄ and ˅ to set
the desired intensity level. Once the setting is complete, press the menu button to switch to the next display.
5 - The display shows the intensity level relative to the bar mounted on channel 4. Use the buttons ˄ and ˅ to set
the desired intensity level. Once the setting is complete, press the menu button to switch to the next display.
6- The display shows the start time of the sunrise scenario. Use the buttons ˄ and ˅ to set the desired hour. Press
the OK button to confirm and move on to minute setting. Confirm again with the OK button and use the menu but-
ton to switch to the next display.
7- The display shows the duration of the sunrise scenario in minutes. Use the ˄ and ˅ buttons to set the desired
duration (5-minute step). Confirm your choice by pressing the OK button and then press the menu button to switch
to the next display.
8- The display shows the start time of the sunset scenario. Use the buttons ˄ and ˅ to set the desired hour. Press
the OK button to confirm and move on to minute setting. Confirm again with the OK button and use the menu but-
ton to switch to the next display.
9- The display shows the duration of the sunset scenario in minutes. Use the ˄ and ˅ buttons to set the desired
duration (5-minute step). Confirm your choice by pressing the OK button and then press the menu button to switch
to the next display.
10- You can start a complete sunrise/day/ sunset cycle with this function. Sunrise and sunset scenarios have a
preset duration of 3 min. Use the ˄ and ˅ buttons to set the duration of the day phase. Press the OK button for
three seconds to start the demonstration.
11- Current time setting.
Use the buttons ˄ and ˅ to set the desired hour. Press the OK button to confirm and move on to minute
setting. You can confirm with the OK button and return to the main display with the menu button.
12- When Powermoon and Airlink are connected, you can determine whether Powermoon should behave
as Master or Slave. To access this display, from the main display press MENU and OK buttons simultane-
ously for 5 seconds. Use the ˄ and ˅ buttons to make your choice and press the OK button for 5 seconds
to confirm your choice.
ENG