Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTRUCTION MANUAL
IMPORTANT SAFEGUARDS
The following basic safety precautions apply when
using electrical appliances:
•
Read all instructions.
•
Before use check that the voltage of wall outlet
correspond to the one shown on the rating plate.
•
Do not operate any appliance with a damaged cord
or plug or after the appliance malfunctions, or is
dropped or damaged in any manner.
Return appliance to the nearest authorized service
facility for examination, repair or electrical or
mechanical adjustment.
•
If the supply cord is damaged it must be replaced by
the manufacturer or a authorized service agent or a
qualified technician in order to avoid a hazard.
•
To protect against risk of electrical shock do not put
in water or other liquid.
•
Close supervision is necessary when any appliance is
used by or near children.
•
Unplug from outlet not in use, before putting on or
taking off parts, and before cleaning.
•
Avoid contacting moving parts.
•
The use of attachments, including canning jars, not
recommended by the manufacturer may cause a risk
of injury to persons.
•
Do not use outdoors
•
Do not let cord hang over edge of a table or counter.
•
Do not let cord contact hot surface, including the
stove.
•
Keep hands and utensils out of container while
blending to reduce the risk of severe injury to
persons or damage to the blender. A scraper may be
used but must be used only when the blender is not
running.
•
To reduce the risk of injury, never place cutter-
assembly blades on base without jar properly
attached.
•
Unplug the appliance immediately after use.
•
Never let the appliance run unattended.
•
Always operate blender with cover in place.
•
If you use the blender have long time, you must run
it on 3 minute rest it 10 minute.
Warning: never use hot liquids or run the appliance
•
empty.
•
Blades are sharp. Handle carefully.
•
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
•
Children should be supervised to ensure that they
do not play with the appliance.
•
Appliances shall be potential injury from misuse.
•
The blender is not to be operated with an empty
blending unit (i.e. without solid or liquid foodstuff ).
•
Do not operate the appliance in dry motion.
•
Do not use for other purpose, it may have injury
from misuse.
SAVE THESE INSTRUCTIONS!
HOW TO USE THE BLENDER
Before using for the first time, wash all parts and
attachments in hot soapy water, rinse and dry
thoroughly.
ASSEMBLE:
1
8
2
9
3
4
5
6
7
1. Jar cover
2. Spout
3. Jar
4. Motor unit
5. Switch
6. Base
7. Foot
8. Measure cup
9. Handle
INSERTING THE JUG
1. Make sure that the blender is switched off (Switch in
the '0' setting).
2. Place the jug ass'y onto the motor block.
CAUTION: NEVER TURN ON THE APPLIANCE UNTIL IT
IS PROPERLY ASSEMBLED.
HOW TO OPERATE THE CONTROLS
The control dial is conveniently located on the front of
the base. Rotate the knob clockwise to select a speed:
1 for Low
2 for High
For instant on and off control, use the PULSE (P) button
by rotating knob counterclockwise.
2
NOTES
•
Wash ingredients well and cut into suitable pieces to
fit into the feeding hole. Add the foods or beverages
into the jug through the feeding hole. The jug has
a capacity of 1.5 liters. Do not overload the jug at a
time.
•
The Pulse switch offers you fingertip control over
short food processing jobs. When switch to Pulse,
the machine will run at high speed.
•
Turn Off to stop the machine.
NOTE: Do not let the machine work with thick mixtures
or heavy foods. If the motor does not run freely, stop the
machine and
• add a little liquid or
• switch to Pulse for a few short bursts or
• stop blending every few seconds and use a rube
spatula to clear the sides of the jug and push
ingredients towards the cutting blades, or
• reduce the contents in the jug
1. The appliance is only permitted to use 3min for
1 time. Before it is used again, it must cool down
enough.
2. When finished processing select OFF (0) or release
from PULSE position. Wait until blade has stopped
rotating before removing lid. Unplug the unit
CLEANING AND MAINTENANCE
NOTE: MAKE SURE THE MACHINE IS OFF AND PLUG IS
DISCONNECTED FROM OUTLET BEFORE PUTTING ON OR
TAKING OFF ANY PARTS.
1. Cleaning is best done immediately after use. Take off
the jug.
2. Particles of food lodging under the blade can be
easily removed with the aid of a small tooth brush
(not attached accessory).
WARNING: THE BLADE IS EXTREMELY SHARP. HANDLE
CAREFULLY.
3. Clean the motor housing with a soft damp cloth.
Do not use abrasive cleaners or scouring pads to
clean the unit. To clean the jug, add 1/4 teaspoon
(no more) of liquid detergent to the jug, and fill to
maximum with warm water. Place the jug on the
motor housing and pulse for a few seconds, two or
three times.
4. Rinse parts under running water. Do not use
a dishwasher or very hot water. Wipe all parts
thoroughly before putting them away after use.
Store the appliance in a dry place. It is recommended
to store the jug with the lid removed.
CAUTION: NEVER IMMERSE THE MOTOR UNIT OR
POWER CORD INTO WATER FOR CLEANING.
If any problem has been encountered during use,
never disassemble the Motor Unit by yourself, there
are no user serviceable parts inside. Contact only the
authorized service facility for examination and repair.
TECHNICAL DATA:
220-240 V ~ 50-60 Hz • 500 W
Environment friendly disposal
You can help protect the environment! Please
remember to respect the local regulations:
hand in the non-working electrical equipments to an
appropriate waste disposal center.
3
Publicité
Table des Matières
