Déclaration D'exposition Aux Radiations - QNAP QHora-301W Guide Rapide

FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device maynot cause harmful interference, and (2) This device must
accept any interference received, including interference that maycause undesired operation.
This equipment has been tested and complies with the Class B digital device limits, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used according to the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference cannot occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference
by taking one of the following actions:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and the receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
FCC Caution
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment. RF Modules installed
in this product must not be co-located or operating in conjunction with any other antenna
or transmitters, except when installed in accordance with FCC multi-transmitter product
guidelines.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for uncontrolled
environments. This equipment must be installed and operated with a minimum distance of
27cm between the radiator/antennas and the general public
This device complies with CE compliance Class B.
CE Marking
The equipment described in this document faithfully complies with: European Union Radio
Equipment Directive (RED) 2014/53/EU. The Declaration of Conformity is provided to
customers with other technical documents upon request and is accessible from https://www.
qnap.com/en/contact-us/ to authorized users. Radiation exposure statement This equipment
complies with radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 27 cm between the
radiator and your body. For operation within 5.15 ~ 5.35GHz frequency range, it is restricted
to indoor environment.
Hereby, QNAP Systems, Inc. declares that the radio equipment type QHora-301W is in
compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address:
www.qnap.com
Data transmission is handled by software. Via software, it can define the rule. When
the equipment has no data to transmit, only the control frame will be sent (like 802.11
management frame, such as beacon and probe Response). When failing to operate, it will
stop the service automatically
ISED Compliance Statement
Note: Industry Canada has been renamed Innovation, Science, and Economic Development
Canada (ISED) following the issue of RSP-100 Issue 11 and DC-01 Issue 06. Equipment
certifications previously issued by Industry Canada remain valid and do not require
updating. Meaning you may see the names used interchangeably in documentation. The
following statement is applicable to ASiR-pRRH which has Innovation, Science and Economic
Development (ISED) approval: This device complies with ICES-003 of Industry Canada's
license-exempt RSSs. Operation is subject to the following two conditions
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme a la nomre ICES-003 du CNR d'Industrie Canada
applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes:
1. L'appareil ne doit pas produire de brouillage.
2. L'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si
lebrouillage est susceptible d'en compromettre le fonctionnement.
Radiation Exposure Statement
This product comply with IC radiation exposure limits set forth for an uncontrolled
environment. To comply with RSS 102 RF exposure compliance requirements, a separation
distance of at least 27 cm must be maintained between the antenna of this device and all
persons.
The device for the band 5150-5350 MHz is only for indoor usage to reduce potential for
harmful interference to co-channel mobile satellite systems.
Déclaration d'exposition aux radiations
Produits sont conformes aux limites IC d'exposition aux rayonnements définies pour
un environnement non contrôlé. Produits doivent être installés et utilisés avec distance
minimum de 27cm entre le radiateur et votre corps.
Les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement
pour une utilisation à l'intérieur afin de réduire les risques de brouillage préjudiciable aux
systèmes de satellites mobiles utilisant les mêmes canaux.
According to the requirement of the WEEE legislation the following user information is
provided to customers for all branded QNAP Electronics products subject to the WEEE
directive.
This symbol on the product or on its packaging indicates that this product must not be
disposed of with your other household waste. Instead, it is your responsibility to dispose of
your waste equipment by handing it over to a designated collection point for the recycling of
waste electrical and electronic equipment. The separate collection and recycling of your
waste equipment at the time of disposal will help to conserve natural resources and ensure
that it is recycled in a manner that protects human health and the environment. For more
information about where you can drop off your waste equipment for recycling, please
contact your local city office, your household waste disposal service or the shop where you
purchased the product.