Table des Matières
Publicité
2 Setting example
2-1 When setting in same room.
Separate setting
Each unit can only be operated by its own wireless re-
mote controller.
"0"
"1"
"0"
"1"
2-2 When setting in different rooms.
Assing a different number to each wireless remote control-
ler and all the Signal Receiving Unit
(Leave the setting as purchase)
(2) Main/Sub switch settings (leave the initial "Main" setting when not using the MA remote controller).
Set the Main/Sub switch when using with the MA remote controller (PAR-20MAA).
Set the signal receiving unit to "Sub" and the MA remote controller (PAR-20MAA) to "Main".
5
How To Install
(1) Choose a place in which to install the Signal Receiving Unit (switch box).
Be sure to observe the following steps:
1 When installing on either the switch box or the wall,allow space around the Signal
Receiving Unit as shown in the figure on the right.
2 When installing the Signal Receiving Unit to the swich box, the Signal Receiving Unit
slipped downward for 6.5 mm as right illustrated.
3 Parts which must be supplied on site.
Switch box for one unit
Thin-copper wiring pipe
Lock nut and bushing
4 lnstall the unit on the wall or ceiling where the signal is received from the remote
controller.
(Refer to the below illustration)
∗ Install the Signal Receiving Unit where is watched from any position.
NOTE: lf the Signal Receiving Unit is installed near a fluoresent lamp specially inverter type,signal interception may occur.
The refore be careful for installing the Signal Receiving Unit or replacing the lamp.
(2) Install the remote control cord to the terminal block. (Polarity is in)
Insert the minus screwdriver toward the
arrow pointed and wrench it to remove the cover.
"2"
"3"
"2"
"3"
90˚
Remote control cord
¡
Single setting
All the units can be operated by a single wireless remote con-
troller.
"0"
"0"
"0"
"0"
"0"
"0"
Example: Ceiling cassette type, Ceiling cosealed type
Signal Receiving Unit
∗ When consealing wire, the hole ø10 to push a remote control
cord through is nesessary on the ceiling.
Push a remote control cord
through the wires installed hole.
™
"0"
"0"
"0"
Signal receiving
70
unit external
Center of
Switch box
Switch box
Installation pitch
Remote controller Cord
ø10
Protrusion
(pillar, etc)
3
Publicité
Table des Matières
