Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
2 - SHOwERHEAD bATTERy CHARGER
The batteries inside the showerhead can be recharged by using the (C) char-
ger equipped with a 2-meter wire. Remove the protective cap and insert the
pin. Inserting the plug into a 220V wall socket, a red light will illuminate. After
charging, the light will turn green. The charger is equipped with an intelligent
system and will automatically disconnect when fully charged. Once charging
is complete, replace the protective cap.
3 - SHOwERHEAD INSTALLATION
The showerhead is equipped with a 1/2" female water inlet. Make the
connection with the water inlet taking care to interpose the appropriate
rubber seal (f).
When tightening the ring, avoid the use of pliers or tools that could damage
the chrome. Simply turn hand vigorously to ensure a good watertight.THe
shower head can be mounted on a shower arm (not included) with a male
water outlet of 1/2".
12
EN
4 - REMOTE CONTROL CAN bE HUNG ON THE wALL
Using the two magnetic plates D included. Thoroughly clean the surface where
the remote control will be placed. Remove the double-sided tape film then push
it to the wall. The other plate must be applied on the back of the remote control.
In this way, the remote control will be hanging on the wall.
f
13
Publicité
Table des Matières
