Lorell LLR84380 Mode D'emploi page 3

FEATURES
A Power Indicator Light
B Power and Setting Control
C Thermostat Control
D Oscillation
OPERATION
• Place the heater on a firm, level surface free from obstructions, and at least 3 ft. (0.9 m) away from any wall
or combustible material.
• With the Power Switch in the OFF position, plug the heater into a grounded 120V outlet. Always operate the
heater in the upright position.
• For fan only function without any heat, push the Power and Setting Control switch (B) to FAN (
the fan will turn on and Power Indicator Light (A) will come on.
For heater function, turn the Power and Setting Control switch (B) clockwise to the desired position LOW (
•
or HIGH ( ), and turn Thermostat Control (C) to your desired setting from MIN to MAX.
• For faster heat up, turn the Power and Setting Control switch (B) to position HIGH (
Thermostat Control (C) to MAX, when the room reaches a comfortable temperature, slowly turn (C)
counter-clockwise until the Power Indicator Light (A) turns off. This is the point at which the thermostat
setting equals the room temperature and the thermostat will automatically turn the heater on and off to
maintain this selected temperature. Then you can turn (B) to position LOW (
prevent overheat.
• For oscillation function, turn the Oscillation (D) switch ON.
Note: If the fan was shut off, either because of by pressing POWER to select OFF, or the unit was turn off
automatically for high room temperature, the oscillation will be off.
RESET INSTRUCTIONS
This heater is equipped with an internal High Limit Switch that causes the unit to stop operating in the event the
internal temperature exceeds normal operating temperatures.
IF THE UNIT SHUTS DOWN
1. TURN THE UNIT OFF
2. UNPLUG UNIT AND WAIT 10 MINUTES
3. PLUG IN AND TURN ON
SYMBOL
OFF
The heater operates at 900 watts
The heater operates at 1500 watts
3
C.
B.
A.
D.
FUNCTION
The heater turns off
Fan working only
) position,
), and turn the
) for energy saving and
)