Installing The Blades; Installing The Monting Plate - Hinkley 54 COLLIER Manuel D'utilisation

INSTALLING THE BLADES

INSTALLING THE MONTING PLATE

Light Wires
Fig. 1
10 | hinkley.com
Screws
Blade
support
plates
Blades
Blade Arms
Screws
Mounting Hub
(bottom of motor)
Adapter
plate
NOTE:
Remove any rubber supports that are installed for
shipping.
Place the screws through the holes in the blade support plates.
Repeat this procedure without tightening the screw until all 3
screws have been started into the blade arm.
Insert the blade through the slot on the housing. Align the holes
on the blade and the fan motor assembly and secure with screws.
NOTE:
Cordless power screwdrivers are NOT recommended,
as they usually strip the heads of the screws and
usually will not fully compress the lock washers on
the motor screws. Use a large flat blade screwdriver
for final tightening to fully compress the washers. This
will help ensure proper alignment of the blades and
noise-free, wobble-free running.
NOTE: Be sure the power is off before installing.
Remove one of the three screws on the mounting hub
1
located on the fan motor. Loosen the other 2 screws. (Do
not remove) (Fig. 1)
Pass the light wires through the center hole of the adapter
2
plate.
Place the key holes on the adapter plate over the 2 screws
3
previously loosened, turn the adapter plate until it locks in
place at the narrow section of the key holes. Secure by
tightening the 2 screws previously loosened and the one
previously removed.