Kimex 049-3 W Serie Notice page 19

Product Electrical Specification
Voltage: 100V~120V or
220V~240V (Refer to label on
casing) Frequency: 50Hz~60Hz
Power: 150W (MAX)
Screen Operation
To lower the projection surface
Press the bottom button on the control unit, the projection surface will lower itself, when it is fully
extended it will stop automatically.
To retract the protection surface
Press the top button on the control unit, the projection surface will retract into its case, when it is fully
retracted it will stop
automatically.
To stop the protection surface
Manually at an intermediate position,
press the middle button on the control unit.
Lower limit—Adjust the stopping level of slat when fully extend.
Turn "lower limit" switch in clockwise direction let the slat go closer
to the ground.
Upper limit—Adjust the stopping level of slat when fully retract.
Turn "upper limit" switch in clockwise direction let the slat go closer
to the casing.
16