Bosch RA1181 Consignes De Fonctionnement/Sécurité page 15

CHART 1
Router Router
Brand Model
Bosch 1613 series
Bosch 1617 series (fixed
base models only)
Bosch 1619EVS
Craftsman Most Craftsman
1/2" collet routers
DeWalt DW616, DW618
(fixed base only)
Hitachi M12VC
Makita RF1100, RF1101
Milwaukee 5615, 5616
Porter Cable 690 series,
7529 plunge router,
and 892–895 series
(fixed base only)
Ryobi R161, R162
ATTACH ROUTER TO MOUNTING PLATE
(Figs. 9 and 10)
1. Remove the plastic subbase from your router
(Fig. 9).
2. If your router has its own dust extraction hood that
mounts to the top of the metal router base and you
want to use it under the router table, this is a
convenient time to install it.
3. Using Chart 1, determine the hardware and mount
type for your router.
• For most router models, the screws are driven into
threaded holes in the router's base (mount type 1).
• For some router models, the screws go all the way
through the base and are fastened with washers
and nuts (mount type 2).
The top and front of the mounting plate is determined
by the location of the guide pin holes. These holes
are to the right of the bit opening.
4. Refer to the mounting plate guide (Fig. 8) on page 14
and align the appropriate mounting plate holes for
your router to the router base holes. Make sure that
the depth adjustment controls on the router face the
front of the mounting plate.
5. Mount your router to the mounting plate (Fig. 10).
Router Table Assembly
Hole Fasteners
Pattern Required
A 1/4-20 x 1
1
washers (27), and 1/4-20 nuts (26)
B #10-24 x 3/4" Pan-head Phillips machine screws (37)
C 1/4-20 x 1 1
washers (27), and 1/4-20 nuts (26)
E 5/16-18 x 3/4" Pan-head Phillips machine screws (39)
B #8-32 x 3/4" Pan-head Phillips machine screws (38)
B #10-32 x 3/4" Pan-head Phillips machine screws (35)
B #10-24 x 3/4" Pan-head Phillips machine screws (37)
B #10-24 x 3/4" Pan-head Phillips machine screws (37)
B #10-24 x 3/4" Pan-head Phillips machine screws (37)
E 5/16-18 x 3/4" Pan-head Phillips machine screws (39)
FIG. 9
FIG. 10
15
" Pan-head Phillips machine screws (36),
⁄
2
" Pan-head Phillips machine screws (36),
⁄
2
REMOVE
SUBBASE
Mount
Type
2
1
2
1
1
1
1
1
1
1