Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions and Parts Manual
Troubleshooting Guide
Stop using tool immediately if any of the following problems occur. Serious personal injury could result.
Any repairs or replacements must be done by a Qualified Service Person or Authorized Service Center.
SYMPTOM
Air leaking at trigger valve
Air leaking between housing
and nose
Air leaking between housing
and cap
Stapler skips driving staples
Stapler runs slow or has loss
of power
Staples are jammed in stapler
CAUSe
O-rings in trigger valve housing are
damaged
1.
Damaged O-rings and / or seals
2.
Damage to bumper
1.
Loose screws
2.
Damaged gasket
1.
Worn bumper
2.
Dirt in nose piece
3.
Dirt or damage prevent staples
or pusher from moving freely in
magazine
4.
Damaged pusher spring
5.
Inadequate air flow to stapler
6.
Worn ring on piston or lack of
lubrication
7.
Damaged o-ring on trigger valve
8.
Air leaks
1.
Stapler not lubricated sufficiently
2.
Broken spring in cylinder cap
3.
Exhaust port in cap is blocked
1.
Guide on driver is worn
2.
Staples are not correct type
3.
Staples are bent
4.
Magazine or nose screws are loose
5.
Driver is damaged
6.
Staples loaded incorrectly
SOLUTION
Replace O-rings.
1.
Replace o-rings and / or seals
2.
Replace bumper
1.
Tighten screws
2.
Replace gasket
1.
Replace bumper
2.
Clean drive channel
3.
Clean magazine
4.
Replace spring
5.
Check fitting, hose, or compressor
6.
Replace piston seals
7.
Replace o-rings
8.
Tighten screws and fitings
1.
Lubricate stapler
2.
Replace spring
3.
Replace damaged internal parts
1.
Replace guide
2.
Use only recommended staples
3.
Replace with undamaged staples
4.
Tighten screws
5.
Replace driver
6.
Review Loading / Unloading section of manual
CHN71600
13
www.chpower.com
Publicité
Chapitres
Table des Matières
Dépannage
