Storage; Maintenance; Clearing A Jam From The Stapler; Stapler Repair - Campbell Hausfeld/Scott Fetzer CHN71600 Instructions D'utilisation Et Manuel De Pièces

Operating Instructions and Parts Manual

Storage

The stapler should be stored in a cool dry location.

Maintenance

ClearINg a jaM FroM tHe StaPler

1. Disconnect stapler from air supply.
2. Remove all fasteners from the magazine (see Loading/ Unloading). Failure to do so
may cause the fasteners to eject from the front of the stapler.
3. Press magazine latch (see Loading / Unloading the Stapler).
4. Open the magazine, exposing the jammed fastener.
5. Remove the jammed fastener, using pliers or a screwdriver if required.
6. Load with staples.
7. Make sure the trigger moves freely without sticking or binding.

StaPler rePaIr

Only qualified personnel should repair the tool and they should use genuine Campbell
Hausfeld replacement parts and accessories, or parts and accessories which perform
equivalently.

rePlaCeMeNt PartS

Use only genuine Campbell Hausfeld service parts. Tool performance,
safety and durability could be reduced if improper parts are used. When
ordering replacement parts, specify by part number.

aSSeMbly ProCedUre For SealS

When repairing a stapler, the internal parts must be cleaned and lubricated. Parker
O-lube or equivalent must be used on all o-rings. Each o-ring must be coated with
O-lube before assembling. A small amount of oil must be used on all moving surfaces
and pivots.

teCHNICal ServICe

For information regarding the operation or repair of this product, please call
1-800-543-6400.

FaSteNer INterCHaNge INForMatIoN

Fasteners used in the Campbell Hausfeld CHN71600 Upholstery Stapler include:
• Arrow T50 staples or any equivalent fastener with the approximate dimensions
illustrated in Figure 10
Figure 9
10.7 mm
9.3 mm
Figure 10
www.chpower.com
CHN71600
1.3 mm
11