Intended Use; Connection To The Drinking Water Network - Kärcher Water Controller Duo Smart Mode D'emploi

 Only operate the watering
valve in a vertical position.
 Do not use sealing compound
or lubricant to connect the wa-
tering valve to the tap.
 Do not operate the device
without the integrated filter at
the water inlet.
 Regularly check the filter at
the water inlet for damage.
Particles in the water which
enter the device through a
damaged filter will prevent the
valve from opening and clos-
ing properly.
 Replace the damaged water
filter immediately.
 Check the device for leaks
and ensure that the valves
open and close reliably if the
device has been shut down for
a long period of time, and al-
ways at least once a month.
 Do not pull on connected hos-
es.
 Observe wall and surface re-
quirements before wall mount-
ing.
 When mounting on the wall,
check the load capacity of the
wall. Mount the device secure-
ly on the wall.
 The device must be accessi-
ble at all times. Do not mount
the device in inaccessible
places or higher than
2 meters.
 Do not install the watering
valve near heat sources and
8
protect it against frost (permit-
ted ambient temperature 5 °C
to 40 °C).
 Only use batteries approved
for your watering valve. You
can find information about the
required battery type in the
operating instructions for your
device.
 Do not use rechargeable bat-
teries.
 Do not install the watering
valve in locations where con-
densation can form.
 Do not operate the watering
valve near devices that are
connected to power.
 Do not start up a device that is
not functioning correctly.
Wireless standards
The devices use the following wireless standards:
 ZigBee (IEEE 802.15.4)
Device Type
Water Con- SRD
troller Duo
Smart
Alfred Kärcher GmbH & Co. KG hereby declares that
the radio system type watering valve (Water Controller
Duo Smart) complies with the Guideline 2014/53/EC.
The complete text of the EU Declaration of Conformity
is available at the following Internet address:
www.kaercher.com
This device has been developed for private use and is
not intended for the loads imposed by commercial use.
This device is intended for connection to a water tap and
automatically controls the water flow in a watering sys-
tem.
The manufacturer accepts no liability for possible dam-
age caused by improper use or incorrect operation.
Connection to the drinking water
Please observe the requirements of EN 1717 when con-
necting this product to the drinking water network and
contact your sanitation specialists if you have any que-
ries.
English
Frequency, Power, max.
MHz ERP
2412 - 2472 10 mW

Intended use

network