AUTO-HAK V63 Mode D'emploi page 6

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
M12x1,25x40
4
6
M12x40
M12x45
M12x1,25x40
This towbar is designed to assembly in following cars:
NISSAN NAVARA (D40) with tubular bumper , produced since 07.2005
till 03.2010 and since 04.2010 till 03.2016, catalogue no. V63 and is
prepared to tow trailers max total weight 3000 kg and max vertical
load 120 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
5
4
M12x1,25x40
1
M12x75
3
2
From manufacturer
1. For the purpose of installings of the towbar one ought to disassemble
the bumper (tubular) and its handles which will not be assembled
again.
2. From the right and left side of the frame fix plates (pos. 4) and side
brackets (pos. 5 and 6) using bolts M12x1,25x40mm (pos. 10) – fix
loosely (see the drawing).
3. Fix the bumper to side brackets (pos. 5 and 6) of the towbar – use bolts
M12x40
previously unscrewed from factory handles.
M12x45
4. Slip the main bar of the towbar (pos. 1) between elements of the towbar
(pos. 4) and fix using bolts M12x40mm (pos. 9).
5. Fix tow-ball (pos. 2) with socket plate (pos. 3) using bolts M12x75mm
M12x40
(pos. 7) from accessories.
6. Tighten all bolts according to the torque shown in the table.
7. Connect electric wires of 7-poles socket according to the instruction of
the car. (Recommend to make at authorized service station).
8. Complete paint layer damaged during installation.
After install the towbar you should get adequate note in registration book
(at authorised service station).The car should be equipped with:
Indicators
Tow mirrors
After 1000km of exploitation check all bolts and nuts. The ball of towbar
must be always kept clear and conserve with a grease.
The instruction of the assembly
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm M 10 - 55 Nm
M 12 - 85 Nm M 14 - 135 Nm
NOTE