COOL WORKS MWDCK-05CMN1-BI7 Manuel D'instructions page 8

Climatiseur de fenêtre
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Please always wait 3 minutes when turning unit off then on again, and when changing
from cool to fan and back to cool. This prevents compressor from overheating & possible
circuit breaker tripping.
Air Directional Louvers
Lever
Air Direction
Operating Instructions
The controls featured in this manual are representative
of many available models. Your model may offer slightly
different features.
Cool Mode
The desired cool setting is selected by rotating the knob to the
right to the appropriate location.
has maximum cooling effect and airflow.
has minimum cooling effect and airflow.
Fan Mode
Rotate the knob to the left to select your choice of fan speeds for air
circulation.
NOTE: When selecting a fan speed, the compressor will not run.
Thermostat
The thermostat is used to set the desired room temperature when the
unit is being operated in the COOL MODE.
To set the desired room temperature, rotate the thermostat switch
to the desired setting. After the set temperature is achieved the
thermostat will automatically start and stop the compressor in order
to maintain the desired set temperature.
Rotate the thermostat selector clockwise for higher cool settings.
Higher cool settings will provide lower room temperature. Rotate
the thermostat selector counter clockwise for lower cool settings.
Lower cool settings will provide higher room temperature.
The louvers will allow you to direct the air flow
left or right throughout the room as needed.
Move the louvers f rom side to side until the desired
left/right direction is obtained.
6

Publicité

Table des Matières
loading

Table des Matières