Hama CC 825L Mode D'emploi page 6

g Operating Instruction
PAPER BLOCKAGE AND OVERLOAD PROTECTION:
The CC 825L has a motor with an overload protection
function. The normal operating cycle for uninterrupted
shredding activity is two minutes continuous operation
followed by approx. fi fteen minutes switched off. The
shredder may switch itself off automatically in the
following cases:
1. If the shredder is used for more than two minutes at
a time.
2. If it becomes overloaded due to more than eight
sheets of paper being fed into the shredder at a time,
or if the paper is not fed into the shredder evenly.
3. For your own safety, if the paper basket is removed
or the front fl ap opened while the shredder is running.
The fi rst two cases can trigger the automatic overload
protection function which interrupts the power supply. If
this is the case, proceed as follows:
1. Remove the plug from the socket and wait at least
fi fteen minutes until the overload prevention function
resets. Remove all remaining paper from the shredder
or cut it off appropriately.
2. Then connect the machine to the mains again and set
the switch to REV. Using the reverse function, pull the
paper trapped in the cutting rollers out of the top of
the shredder. You can then set the switch back to
AUTO.
3. If the switch is set to „AUTO" and the paper feeder is
clear, the shredder is now ready to use again.
SPECIFICATIONS:
• Slitting size: 4 x 40 mm (cross-cut)
• Slitting capacity: 8 sheets
• Slitting speed: 2.2 m/min.
• Max. feed width: 220 mm
• Mains supply: 220 - 240 V ~
• Dimensions of the CC 825L: 310x410 mm
5