Operation Modes; Safety Instructions - Hama CC 825L Mode D'emploi

g Operating Instruction
Shredder CC 825L, automatic
The CC 825L is a shredder whose extravagant, rounded
design makes it easy to fi t into any modern offi ce or
home. It is equipped with a large 25-litre basket which
catches the shredded paper. In addition , you can
simply dispose of whole sheets of paper by opening the
separate fl ap.
For your safety, the device stops running automatically
if you open the front fl ap or lift the shredder from the
paper basket. Thus, getting your hand caught in the run-
ning slitting mechanism accidentally is hardly possible.

SAFETY INSTRUCTIONS:

1. Read all instructions thoroughly before using the
machine.
2. Place the cable in such a way that no one will trip
over it.
3. Never open the housing of the shredder.
4. Do not operate the device if it is wet.
5. Switch off the device when not in use and remove
the plug from the socket.
6. Stop using the machine if there is damage to the
cable, housing or holder.
INSTALLATION:
1. Remove all packaging materials from the device.
2. Place the shredder on a stable, even surface.
3. Connect the power cable to a 220-240 V~ outlet.
4. Set the switch to „AUTO". If the green light does not
go on after this, the paper basket may not have been
inserted properly. Remove the shredder from the
basket again and position it once more correctly.
4

OPERATION MODES:

Using the switch on the device, select one of the
following modes.
AUTO – On this setting, the shredder switches itself on
automatically as soon as you insert paper into the paper
feeder and switches itself off automatically when there
is no more paper.
REV – In the unlikely case of paper being trapped in the
cutter, the reverse function allows you to remove the
blockage.
OFF – This setting switches off the shredder.
SLITTING CAPACITY:
The CC 825L can shred up to eight sheets of 75 g/m² pa-
per with a maximum width of 220 mm at the same time.
A FOLDED SHEET OF PAPER IS THE EQUIVALENT OF
TWO SHEETS!
WARNING:
1. Make sure you do not insert things such as clothes,
ties, jewellery or hair into the paper feeder.
2. Set the switch to OFF if you will not use the shredder
for a prolonged period of time.
3. Remove any paper clips and staples from the paper
before shredding. The shredder will not break if you
forget to do this once in a while. However, you should
normally avoid this.
4. Keep hands and fi ngers away from the underside of
the shredder during operation and especially from
the cutting rollers, as this can cause serious injury.
5. The runtime of the shredder should not exceed two
minutes at a time. If you have a large quantity of
paper to shred, we recommend that you switch off
the shredder after two minutes of continuous operation
and wait approx. fi fteen minutes before switching it
back on!
6. The socket you use should be close to the shredder
and easily accessible!
7. Always switch the shredder off (or remove the mains
plug) before moving or cleaning the shredder or
emptying the paper basket.
8. Empty the paper basket regularly.