Télécharger Imprimer la page

Guide Bar And Saw Chain Installation - Echo REPOWER 90093 Instructions D'installation

Publicité

Les langues disponibles

Les langues disponibles

2

guIdE Bar and saW chaIn InsTallaTIOn

4.
Remove two (2) 6 mm guide bar nuts (C) and remove sprocket
cover (D).
5.
Turn saw chain tension adjuster slot (E) counterclockwise until it
stops.
6.
Install chain on guide bar, with cutters on top of bar facing toward
bar tip.
7.
Install guide bar and chain on gear case, engaging chain with
drive sprocket.
8.
Turn tension adjustment slot clockwise to take up slack in saw
chain.
9.
Install sprocket guard, and tighten guide bar nuts (C) finger tight.
10. Adjust chain tension. See Saw Chain Tension Adjustment In-
structions on Page 4 of this manual.
11. Loosen the four (4) bolts (F) and remove locator bolt (G) from
cutting attachment.
12. Align ridges on aluminum shaft tube (H) with seams in cutting at-
tachment. Join star shaped drive end of inner power transmission
shaft (I) with cutting attachment square shaft (J).
P
ower
I
I
nsTallaTIon
nsTrucTIons
d
E
c
g
h
i
J
P
TM
runer
c
f

Publicité

loading