Echo REPOWER 90093 Instructions D'installation

FOr MODELS: PP-1200, 1250, 1260, 1400
PPT-230, 231, PPT-260, 261, PPT-2100, 2400,
PPFD-2400
cuTTIng aTTachMEnT TO shafT TuBE InsTallaTIOn
Tools Required: 10 mm hex socket wrench, screwdriver, 4 mm hex
key wrench. Drill, 7 mm (1/4 in.) drill bit.
warning
Saw Chain is sharp! Always wear gloves when handling assembly,
otherwise serious personal injury may result.
1. Follow Guide Bar and Saw Chain Replacement Instructions in
your Operator's Manual to remove guide bar and saw chain from
existing cutting attachment.
note
If standard guide bar with front-access chain tensioner will be
used, remove chain tensioner and install parts on new gear case.
Follow guide bar and saw chain installation, adjustment, and
replacement instructions in your original operator's manual. If
mounting the side access Intenz
provided here.
2. Loosen four (4) screws (A) and locator screw (B), and remove
existing cutting attachment from aluminum shaft tube.
3. OLDER POWER PRUNER MODELS ONLY:
Loosen 4 clamp screws and remove locator screw from Gear
Case. Slide Gear Case on driveshaft tube and align with power
head. Be certain square inner drive shaft engages into square
socket of gear case. If driveshaft and gear case locator holes do
not match, drill a 7 mm (1/4 in. ) hole through one side of shaft
tube, using locator hole in Gear Case as a guide. Remove burrs
from hole, and clear all debris from tube after drilling.
note
Do not allow drill bit to contact inner driveshaft, otherwise drive-
shaft may be damaged.
X7502307301
guide bar, follow instructions
TM
I I
nsTallaTIOn nsTrucTIOns
TM
rEpOWEr gEar casE
parT nuMBEr
BOTTOM
VIEW
90093
B
X750008561
09/05