Operation; To Turn On/Off; To Adjust The Temperature; Timer Setting - Furrion FF23SW15A-BL Manuel D'instructions

Operation

NOTE: For your safety, this fireplace
is equipped with a proximity sensor
device. When objects are detected
within six inches, the fireplace will
automatically cut out and a red LED will
flash. The fireplace will not come back
on without being reset.
Remove the marketing sticker from
the front glass and the protective
film before use. Operation of the unit
without complete removal of the
protective film may increase the risk of
fire and/or product damage or injury.
Marketing Sticker

To Turn On/Off

Press on control panel or on the
remote control to turn on/off the
fireplace.

To Adjust the Temperature

Press on the remote control to
increase the heat input, press
decrease the heat output.

Timer Setting

Press on control panel or on the
remote control will allow you to set the
timer of heating. You may set the time
from 30 minutes to 5 hours.

Interior Brightness Control

Press
the remote control to select the desired
brightness levels.
For FF23SC15A-BL, FF23SC15A-SS,
FF30SC15A-BL, FF30SC15A-SS,
FF34SC15A-BL, FF34SC15A-SS,
FF40SC15A-BL, FF40SC15A-SS,
FF48SC15A-BL, FF48SC15A-SS,
FF60SC15A-BL and FF60SC15A-SS
models, Press
or on the remote control to change the
flame color. Press and hold for three
seconds to select the desired brightness
levels.

Thermostat Control

Press button on control panel or on the
remote control to adjust the temperature
to your individual requirements.
● Press once to activate the low heat
setting.
● Press twice to select the high heat
setting.
● Press the button a third time to turn
off the fireplace.
● When the fireplace is turning on,
press button for five seconds
to allow you to select the desired
to
temperature settings.
NOTE: When the fireplace is turning
on, press
toggle between
button on control panel or on
button on control panel
button for five seconds will
C and F.
o o
10