Test Run - ShowerLux Prime Line Free Instructions De Montage

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

tESt run:

Once installation work has been completed, i.e. before it is tiled in place, the Prime Line
Sparkling + Music must undergo a test run
Clean the bathtub thoroughly before filling for the first time
Fill the bathtub with water (inlet temperature 40 +/- 5 °C) until whirlpool operation is assured
Turn on the systems and let them run for 10 minutes under supervision. During this, check all
the functions described in the operating instructions
After a further 10 min, switch the Prime Line Sparkling + Music off and then check all of the
piping systems, the drain and overflow fittings for any leaks. Caution:
Do not drain the bathtub
Check that all of the water runs out when emptying the bathtub
If any rework (component adjustment, component replacement) be required, this process
must be repeated
Grout the bathtub with silicone grouting in accordance with the instructions
notes about use:
The Prime Line Sparkling + Music must be cleaned and blown out after every use (also see
the operating instructions)
We recommend the Duscholux bathtub cleaning agent (Art. no. 699.903200) and the
Duscholux whirlpool disinfectant (699.903310) for cleaning and care
Do not use chlorine-based cleaning agents or solvents; this can cause damage to the pipework
Do not use any abrasive cleaning agents
Do not use any oil-based or foaming bath additives
14

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Prime line sparkling + music

Table des Matières