Safety Seat Use Method - asalvo CRECE FIX Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 32
Always secure your baby in the car seat using the harness.
Never leave your baby unattended in the car seat.
Never allow the strap end to become caught in moving parts (e.g. automatic
doors, escalators, etc.).
Caution! The plastic parts of the car seat heat up in the sun, so that your baby may
get burnt. Protect your baby and the car seat against intensive solar radiation
(e.g. by putting a light cloth over the seat).
Take your baby out of the car seat as often as possible to relieve its spine. We
recommend frequent breaks during long journeys. Even outside of the car, please
avoid leaving your baby in the car seat for too long.
1
HOW TO USE THE HARNESS
BUCKLE
Hold the two buckle latches
together.
Make sure the right side is up.
Engage them before putting them
into the harness buckle, which
should make a CLICK noise.
Pull shoulder straps to remove
all slack from the lap section
ensuring that the harness is lying
flat and the harness buckle is
locked.
2
REMOVING 5-POINT HARNESS
A. Removing Shoulder Pads and
Belts
Loosen the 5—point harness of the
child seat as much as possible by
press the button of the shoulder belt
height adjuster.

SAFETY SEAT USE METHOD

A.
INSTRUCTIONS
EN

Publicité

Table des Matières
loading

Produits Connexes pour asalvo CRECE FIX

Table des Matières