Bluetooth ® Pairing - Marshall OVER EAR Mode D'emploi

Table des Matières

Publicité

MONITOR BLUETOOTH
COMBINES HI-FI PROWESS AND BLUETOOTH aptX
®
AUDIO QUALITY ON A SINGLE CHARGE*. MONITOR BLUETOOTH'S ERGONOMIC OVER-EAR CONSTRUCTION DELIVERS SUPERIOR
NOISE ISOLATION WITHOUT THE BULK, STAYING LIGHT ON YOUR EARS THROUGH HOURS OF LISTENING. BLACK VINYL, BRASS
ACCENTS AND THE EMBOSSED MARSHALL SCRIPT GIVE MONITOR BLUETOOTH THAT ICONIC LOOK, WHILE THE FOLDABLE
DESIGN, HEAVY-DUTY CAST METAL HINGES AND A CANVAS CARRYING CASE PROVIDE EXTRA PROTECTION FOR WHEREVER
THE ROAD TAKES YOU
DEVICE LAYOUT
A. POWER BUTTON /
CONTROL KNOB
B. MICRO USB SOCKET
FOR CHARGING
C. 3.5MM INPUT/
OUTPUT SOCKET
D. LED INDICATOR
E. MICROPHONE
CONTROLS
ANSWER INCOMING CALL:
x1
x1
SINGLE CLICK THE
CONTROL KNOB.
END CALL:
x1
x1
SINGLE CLICK THE
CONTROL KNOB.
REJECT CALL:
x2
x1
DOUBLE CLICK THE
CONTROL KNOB.
003
ENGLISH
TECHNOLOGY TO GIVE 30 + HOURS OF EXCEPTIONAL
®
A
D
B
C
E
PLAY OR PAUSE A SONG:
TURN VOLUME UP:
x1
SINGLE CLICK THE
PUSH THE CONTROL
CONTROL KNOB.
KNOB UPWARD.
NEXT SONG:
TURN VOLUME DOWN:
x1
PUSH THE CONTROL
PUSH THE CONTROL
KNOB TO THE RIGHT.
KNOB DOWNWARD.
PREVIOUS SONG:
PUSH THE CONTROL
KNOB TO THE LEFT.
*Calculated with randomly selected music
content playing at medium volume
POWER ON/OFF
CHARGING
1
00:03
=
2
00:03
=
1. PUSH AND HOLD THE POWER BUTTON FOR 3
THE LED INDICATOR STARTS BLINKING RED WHEN THE BATTERY LEVEL IS LOW.
SECONDS TO TURN ON.
1. PLUG THE INCLUDED USB CABLE INTO THE MICRO USB SOCKET ON THE HEADPHONE.
2. PUSH AND HOLD THE POWER BUTTON FOR 3
2. PLUG THE OTHER END OF THE CABLE INTO A USB POWER SOURCE. THE LED INDICTATOR
SECONDS TO TURN OFF.
STAYS LIT WHEN CHARGING.
3. WHEN THE BATTERY IS FULLY CHARGED, THE LED INDICATOR TURNS WHITE.
NOTE: IF NOT CONNECTED TO A SOUND SOURCE
NOTE: CHARGE THE BATTERY BEFORE USING THE HEADPHONES THE FIRST TIME. 2 HOURS
THE HEADPHONES WILL AUTOMATICALLY TURN
CHARGE GIVES APPROXIMATELY 8 HOURS OF PLAYBACK AT MEDIUM VOLUME.
OFF AFTER 10 MINUTES.
BLUETOOTH
®
PAIRING
1
2
00:05
00:05
:
=
:
1. WHEN OFF: PRESS AND HOLD POWER BUTTON FOR 5 SECONDS.
2. WHEN ON: FIRST POWER OFF, THEN PRESS AND HOLD POWER BUTTON FOR 5 SECONDS.
3. ENABLE BLUETOOTH ON YOUR DEVICE. SELECT "MONITOR BLUETOOTH" IN THE BLUETOOTH LIST AND ACCEPT PAIRING. THE LED INDICATOR
TURNS OFF WHEN THE PAIRING IS COMPLETED.
NOTE: UNIT ENTERS PAIRING MODE WHEN POWERED ON FOR THE FIRST USE. AFTER THE INITIAL PAIRING, THE HEADPHONES WILL AUTOMATICALLY
CONNECT TO THE DEVICE WHEN TURNED ON AGAIN.
1
2
3
3
=
=
ENGLISH
004

Publicité

Table des Matières
loading

Produits Connexes pour Marshall OVER EAR

Table des Matières