Assembly Of Machine - Texas 550H Mode D'emploi

Assembly of machine

Remove all components from the packing case, make sure each log splitter is packed in
one carton and place the components neatly so that they may be identified and checked
for any possible damage during transit. Should any component be found damaged, please
contact your Texas dealer immediately.
A: Log guiding plates
B: Log pusher
C: Operation handles
D: Wheels
E: Oil pump
F: Motor start switch
G: Motor
H: Supporting legs
I: Main frame
J: Wedge
Fig. 1 Display of main components. Check all components with reference to the following
list (Fig 1).
Wheels and leg assembly
Unpack the log splitter carefully with the
assistance of another person, rest it on the
polyfoam block (packed together with the
machine in a box) on a supported surface.
Place the main frame on the polyfoam block and fix the
supporting leg (25) with two bolts (74) and two nuts and
tighten it safely.
With the main frame supported by the polyfoam block
and the assembled supporting leg, wheels shall be
mounted on the frame of the machine. Make sure the
wheels are in balance and that they can rotate evenly.
If you by accident place the log splitter as described
in Fig 4, the engine fan cover (18) may leave its
Housing and interfere with the cooling fan.
This will produce a machinery noise while working.
In order to avoid this, remove the fan cover from
its housing (pull it) and re-position it properly.
15