Check Before Use; How To Operate The Unit; Pre-Ignition Preparations And Check Points - Inverter 3026 CE Mode D'emploi

Note:
* If filling fuel in a cold place and the tank is filled to less than half, open fuel
feeder cap for a time, until the temperature of the fuel adjusts to room
temperature before replacing the tank.
If fuel is running low...
If the heater continues to run (for about 20-40 minutes), the unit will
automatically shut off , and the alarm will sound, and the fuel sign (OIL) together
with the « ON/OFF » lamp will blink rapidly.
Note : After automatic shut-off, fill the fuel tank before using again.

4) CHECK BEFORE USE.

1. Make sure that there are no fuel leaks around the unit.
If any leaks are found, remove the fuel tank from the
unit and consult a dealer.
2. Power: The Plug must be securely in the socket.
Use a properly wired household wall socket (single
phase 230V / 240V 50Hz).
3. Control the fuel tank every time you fill it. If you see any
leak, a deformation or signs of rust, please do replace
immediately your fuel tank by going to your reseller or

7. HOW TO OPERATE THE UNIT

1) Pre-ignition preparations and check points

Level:
*
The Unit is required to be placed in a level position.
If the Unit is not level, this can result in incorrect combustion and the flames
may burn high or red. If this happens auto shut-off device will be activated and
the heater will automatically be shut off.
49