Technical Specification; On/Off Function - Ark-One E-RIDE Série Manuel D'utilisation

Keep the instructions for future.
NF EN 14619 - CLASS A : 100 kg MAX
READ THE INSTRUCTIONS PROVIDED BY THE MANUFACTURER BEFORE USING.
1 - SAFE USE OF THE ELECTRIC SCOOTER
The appliance may be used by children over the age of 8 years and by
persons with reduced physical, sensory or mental capacity or by persons
with a lack of experience or knowledge if they are supervised or have
+
been instructed on the safe use of the appliance and they have under-
stood the potential dangers of using the appliance. Children must not
play with the appliance. Cleaning and user maintenance must not be
carried out by children without supervision.

2 - TECHNICAL SPECIFICATION

g
Material
Folding Size
Open Size
Weight
Minimum user height / maximum weight
Maximum Speed
Maximum mileage per charge
Operating temperature
Nominal Power
Front Wheel Size
Rear Wheel Size
Battery Capacity (Ah)
Battery voltage
Charger
Charging time
Sealing around compartment
3 - IGNITION BUTTON FUNCTIONS AND SCREEN FUNCTIONS

ON/OFF FUNCTION

To switch the appliance on or off, press and hold the
Aluminium
side of the screen until the central screen switches on. 5 LEDs on the screen
97 x 45,5 x 42 cm
display the battery charge status
97 x 45,5 x 113,5 cm
CHANGING THE MAXIMUM SPEED
9,2 kg
To select your maximum speed, briefly press the
1,55 m/100 kg have a choice of several speeds:
P0 – P1 – P2 - P3 (from the lowest "P0" to the highest "P3").
20 km/h
The accelerator trigger on the right handlebar allows you to regulate the
~ 7-10 KM*
speed up to the maximum saved speed (from P0 to P3)
0°C / 45°C
LIGHTING
250 W
To switch the light on or off, briefly press the
6" (15 cm)
The lighting switches on the front LED light and the LED on the rear brake.
6" (15 cm)
CHANGING THE DRIVING SETTINGS
5 Ah
Press the
24 V enter the settings interface. In the interface, briefly press
or C3 in the menu.
AC input 100-240v 50/60HZ
a) C1 / unit of measurement: Briefly press
DC output 29,4 V 2 A
ment between km/h and mph.
b) C2 / Start mode: Briefly press
+/- 4 Hours
- If the
IP54
- If the
erator trigger
Motor error
Accelerator error
Breaking error
button and the button simultaneously for 1 or 2 seconds to
to change the scooter start mode:
symbol is displayed, the scooter is started by pushing off with the foot*
is not displayed, the scooter is started directly by operating the accel-
ENGLISH
Speed
Speed unit
Battery level
Front light
Speed regulator
Start mode
button on the right
button on the left side. You
button.
to change C1 – C2
to change the unit of measure-
9