Kichler VASSAR LED Manuel D'instructions page 9

HANGING THE FAN
(continued)
Step 8. Slip the coupling cover , canopy cover and canopy onto the
Downrod
downrod. (Fig. 9)
Canopy
Thread the hanger ball onto the downrod, insert the cross pin through
the downrod and tighten. Now tighten the set screw. (Fig. 9)
Canopy cover
Step 9. Lift the motor assembly into position and place the hanger ball
Coupling cover
into the ceiling mounting bracket.
Set screws
Rotate the entire assembly until the "Check Tab" has dropped into the
"Registration Slot" and seats firmly. (Fig. 10)
The entire motor assembly should not rotate (left or right) when seated
properly.
Retaining clip
Hitch pin
WARNING: Failure to reattach the cross pin and seat the "Check Tab"
can cause the fan to fall from the ceiling during operation. Take special
care to make sure this pin is reattached.
Fig. 9
Registration slot
Fig. 10
52" VASSAR LED | 9
TM